A:  Keep it charging in the charger! The transmitter must remain in the charger 24/7 when not in use. Not keeping it charged will void the warranty. After your hunt, clean off any residue (blood, dirt, grass, etc.), and begin to charge it.

A:  The Pro-Tracker® System consists of three components:

•   An 7075 Aluminum Carrier that screws into your arrow and holds the transmitter

•   A Transmitter (with a barbed hook) attaches to the animal when it is hit with the arrow & emits a radio signal after it is ejected from the arrow.

•   A Receiver that tracks the transmitters radio signal once it attaches to the animal.

These three work together with your tracking skills to recover your animal faster after the shot.

A:  The contacts on the transmitter must be cleaned off of any blood or residue to allow for proper charging.  Also, we do recommend keeping your transmitter charging in the charging station whenever not being used to maintain optimal charging capability.

A.  Yes, the transmitter is waterproof. It is absolutely necessary that it is waterproof… think of the blood! Don’t be afraid to take out in the rain!

The Receiver is only water resistant and cannot be submerged under water.

A.  Slow Down!  When trying to locate your animal and get a reading from the receiver please allow a few seconds in each direction to allow adequate time for the transmitter and receiver to “talk”

A.  Did you cut your existing arrow 3.5″ shorter before adding the carrier?  The arrow must be cut down so when the carrier is attached it will be the length of the original arrow.

Make sure the hook is in the straight up position.  A hook that is tilted right or left may cause the arrow to drift.

Lastly, make sure when your arrow is pulled back that the carrier is pulled up onto your rest.  The carrier was designed to be raised up on the rest to help compensate for any drop.

A. The arrow will need to be shortened 3.5 inches. You’ll need to deduct the weight of 3.5 inches. Depending on the spine and type of arrow, this can, on average, range from 35–45 grains.

• The 7075 Aluminum Carrier: 100 grains (But remember, you’ll be cutting off that 3.5 inches. The weight to your arrow is more like 55–65 grains. 
• The Transmitter: 120 grains
• The Dummy Transmitter: 120 grains
• Retainer Clips: 3.5 grains

Its groundbreaking design screws into the shaft, keeping the majority of the mass in the center of the arrow at the front of the shaft. The added weight gives the arrow more kinetic energy to penetrate deeper into your animal. Its location also helps keep the arrow balanced and allows the arrow to rotate to keep your shot true to your target. When your bow is drawn, the carrier raises the arrow about 2 mm to help compensate for the additional weight. The system comes with a practice dummy transmitter so you can make sure your pins are set correctly to be accurate with the system. Most bowhunters (90%) have reported to us they haven’t needed to re-sight. 

A. The Receiver has a digital display that tells you how far away the transmitter is, what number transmitter you are following, the time of day, how long you have been tracking the animal and the battery life of the receiver.  You are able to program 6 different transmitter numbers into it, making it a system that can be shared by the whole family or with your hunting buddies. The display is easily read in the daytime and has a backlit display that can be turned on at night to track that last minute giant buck that emerges from the trees at dusk. Nothing more fun than tracking your animal in the pitch black woods!

A. Absolutely! They work great with all broad-heads.

A. The Pro-Tracker® System uses a plastic Shear Pin system to connect the Transmitter & Aluminum Carrier together. The Transmitter stays secure in the Aluminum Carrier when the arrow is released and the Shear Pin connection is broken when the arrow impacts with your animal. It only takes the impact of hitting your target to break the shear pin connection.

A. Yes it does. But the velocity at which crossbows shoot bolts creates a g-force that strains the shear pin connection. Therefore, if you are using Pro-Tracker® with your crossbow, we give you a set of Crossbow Secure Bands that help hold the Transmitter in place. This way the transmitter stays connected until impacting your animal.

A. The Pro-Tracker has a range up to 2 miles but it will vary in dense areas, could be 1 mile, 1.75 miles, etc. The receiver will start receiving a signal the moment the transmitter is shot allowing you to track your animal asap.

A.  The batteries are low, replace them immediately.

A. The Transmitter is rechargeable and it’s charger uses a USB cable for power just like your cell phone. While the Transmitter is connected to the carrier it uses no power until it is attached to the animal. Once it is attached to the animal it has 18-20 hours of battery life in order for you to find and recover your animal. Plenty of time to do what you need to do.

A. We decided to use Radio Frequencies in our Transmitters for a number of reasons. First is the varying terrain that hunters encounter in the wild sometimes does not lend itself to finding enough satellites to bounce the location off of for GPS. Second, the battery size needed to power a GPS system is too big to fit inside of our transmitter and weighs more than the one we use for our Radio Frequency Devices. Bluetooth devices have a very limited range. A bluetooth device has a maximum range of 50 yards while with radio frequency we have a range of 2 miles. That is over 70 times the distance.

A. It works. After thorough testing we have determined it is what is needed to hold up with the impact. It gives use the most accuracy with the most durability. Better big than losing a wounded animal.